| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| uccnc settings? http://www-.luthiersforum.com/forum/viewtopic.php?f=10106&t=47256 |
Page 1 of 1 |
| Author: | bfeils [ Wed Feb 10, 2016 8:00 pm ] |
| Post subject: | uccnc settings? |
Hey guys, I'm finally gettting around to setting up my router and I'm having some problems setting up uccnc. Can some of you uccnc users share your axis configuration settings? I'm using a uc300 into a mx3660 with 312oz nema 23 motors. Thanks guys |
|
| Author: | rlrhett [ Wed Feb 10, 2016 10:51 pm ] |
| Post subject: | Re: uccnc settings? |
FWIW I was never able to get uccnc to work on a Widow 10. I got NO assistance from the developer. He insisted HE had it working on his machine, so that was that. When I posted my issue on cnczone he flamed my post. YMMV. Sent from my iPhone using Tapatalk |
|
| Author: | bfeils [ Wed Feb 10, 2016 11:16 pm ] |
| Post subject: | Re: uccnc settings? |
That sucks, I've heard their support is kinda crappy. I kept Windows 7 on my computer because I didn't trust when they said it'll run on Windows 10. |
|
| Author: | Andy Birko [ Sun Feb 14, 2016 4:51 pm ] |
| Post subject: | Re: uccnc settings? |
I'm using UCCNC on a machine of mine but my settings won't help you out. What in particular are you having trouble with? |
|
| Author: | bfeils [ Tue Feb 16, 2016 8:56 pm ] |
| Post subject: | Re: uccnc settings? |
Thanks Andy, I actually just came to update and say I think I got it figured out. I was having a hard time with setting the steps per unit. The problem was, depending on what i had it set at the motors sounded almost like they were grinding. I brought in a xml file from leadshine and that seemed to get rid of it although I'm not sure why it worked. now I can change the steps per unit and it sounds good and runs smooth. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|